Adjustable MOA Elevation Picatinny Scope Rings | 30 mm Diameter | Includes 1 inch Diameter Inserts

Monstrum Adjustable Elevation Scope Rings allow for the scope plane to be angled downward to provide a greater range of downward elevation adjustment for longer distance shots.

• Secure scope rings to your rifle receiver. Rings should be positioned to optimize for correct eye relief and comfortable cheek weld position.
• Scope rings should be in top or bottom position for scope mounting to help ensure a level plane.
• Loosen and secure scope rings using the two large set screws on the side of the scope ring base. 
• Mount scope, incrementally tightening individual scope ring screws using a criss-cross pattern to prevent stripping.
• Screws should be torqued to 20 in/lbs. Use a level bubble or scope leveling tool to ensure scope is mounted on a level plane.
• For height adjustment, raise or lower the rings in tandem to your desired scope height. Use a scope leveling tool to ensure scope is mounted on a level plane.
• Tighten the two set screws to secure in place.
• For elevation adjustment, raise the rear scope ring slightly higher than the front scope ring.
• The innovative scope ring design allows the rings to be angled in tandem in a level downward plane. Use a gun vise and a sighting tool to measure the downward adjustment of the scope. Tighten the two set screws to secure in place.
• The rings can be adjusted from 1.20 of height up to 1.50 inch of height, measured from rail surface to the center height of the optic.

30 mm in diameter, the rings are built for use with standard 30 mm scope tubes. Includes 1 inch inserts for compatibility with 1 inch diameter scope tubes.

The Picatinny base is compatible with all Picatinny mounting systems. It is not compatible with Weaver mounts.